Command Line Reference Guide

sFlow | 969
Example
Figure 38-1. show sflow Command Output
Related
Commands
sflow extended-router enable
e
Enable packing information on a router and switch.
Syntax
sflow extended-router [extended-switch] enable
To disable packing information, use the no sflow extended-router [extended-switch] enable
command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the
E-Series to provide extended gateway information in cases where the destination IP addresses are
learned by different routing protocols, and for cases where the destination is reachable over ECMP.
Related
Commands
sflow extended-switch enable
c e s
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Force10#show sflow
sFlow services are enabled
Global default sampling rate: 64
Global default counter polling interval: 1000
Global extended information enabled: gateway, router, switch
1 collectors configured
Collector IP addr: 20.20.20.2, Agent IP addr: 10.11.201.7, UDP port: 6343
1732336 UDP packets exported
0 UDP packets dropped
12510225 sFlow samples collected
0 sFlow samples dropped due to sub-sampling
Force10#
show sflow Display the sFlow configuration
extended-switch Enter the keyword extended-switch to collect extended switch information.
enable Enter the keyword enable to enable global extended information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series
sflow extended-gateway enable Enable packing information on an extended gateway
sflow extended-switch enable Enable packing information on a switch.
show sflow Display the sFlow configuration