Command Line Reference Guide

sFlow | 967
Usage
Information
You can specify up to 2 sFlow collectors. If 2 collectors are specified, the samples are sent to both.
As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS will
return the corresponding configured agent IP in MIB requests. FTOS checks to ensure that two entries
are not configured for the same collector IP with a different agent IP. Should that happen, FTOS
generates the following error:
%Error: Different agent-addr attempted for an existing collector
sflow enable (Global)
c e s
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default
Command Modes
CONFIGURATION
Command
History
Usage
Information
sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual
interfaces where sFlow sampling is desired.
Related
Commands
sflow enable (Interface)
c e s
Enable sFlow on Interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default on all interfaces
Command Modes
INTERFACE
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.5.1.0 Expanded the no form of the command to mirror the syntax used to configure
Version 6.2.1.1 Introduced on E-Series
Version 8.3.5.0 Introduced on S55
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
sflow enable (Interface) Enable sFlow on Interfaces.