Command Line Reference Guide

966 | sFlow
www.dell.com | support.dell.com
Commands
The sFlow commands are:
• sflow collector
• sflow enable (Global)
• sflow enable (Interface)
• sflow extended-gateway enable
• sflow extended-router enable
• sflow extended-switch enable
• sflow polling-interval (Global)
• sflow polling-interval (Interface)
• sflow sample-rate (Global)
• sflow sample-rate (Interface)
• show sflow
• show sflow linecard
sflow collector
c e s
Specify a collector(s) to which sFlow datagrams are forwarded.
Syntax
sflow collector ip-address agent-addr ip-address [number [max-datagram-size number]] |
[max-datagram-size number]
To delete the specified collector(s), use the no sflow collector ip-address agent-addr ip-address
[number [max-datagram-size number]] | [max-datagram-size number] command
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip-address
Enter the ip address of the collector in dotted decimal format.
agent-addr ip-address Enter the keyword agent-addr followed by the sFlow agent IP
address in dotted decimal format.
number
(OPTIONAL) Enter the udp port number (User Datagram
Protocol).
Range: 0 to 65535
Default: 6343
max-datagram-size number
(OPTIONAL) Enter the keyword max-datagram-size
followed by the size number in bytes.
Range: 400 to 1500
Default: 1400
Version 8.3.5.0 Introduced on S55
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale