Command Line Reference Guide

Control and Monitoring | 89
Related
Commands
reload
c e s
Reboot FTOS.
Syntax
reload
Command Modes
EXEC Privilege
Command
History
Usage
Information
If there is a change in the configuration, FTOS will prompt you to save the new configuration. Or you
can save your running configuration with the copy running-config command.
Refer to Chapter 9, Bare Metal Provisioning for information related to the BMP reload options.
Related
Commands
reset
c e
Reset a line card, RPM, or a failed SFM (TeraScale only).
Syntax
reset {linecard number [hard | power-cycle] | rpm number [hard | power-cycle ] | sfm slot
number
}
Parameters
power-off Power off a line card or standby SFM.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
reset Reset a line card, RPM, or a failed SFM (TeraScale and ExaScale).
reset stack-unit Reset any designated stack member except the management unit
reload-type Configure a switch to reload in normal mode or as a DHCP client with all ports
configured for Layer 3 traffic.
linecard number Enter the keyword linecard and a number for the line card slot number.
(Optional) Add the keyword
hard or power-cycle (power-cycle is C-Series
only) to power cycle the line card.
C-Series Range: 0-7
E-Series Range: 0 to 13 on E1200/E1200i, 0 to 6 on E600/E600i, and 0 to 5 on E300
hard Enter the keyword hard to power cycle the line card.
power-cycle Enter the keyword power-cycle after upgrading a C-Series FPGA to cause the
FPGA to be reprogrammed based on the contents of the FPGA PROM.
Note: This option is supported on C-Series only.