Command Line Reference Guide

876 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
output-delay
c e s
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, enter no output-delay.
Parameters
Default
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
c e s
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
delay
Specify a number of milliseconds as the delay interval.
Range: 8 to 50.
Version 8.3.5.0 Introduced on S55
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface
Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number from 1
to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on C-Series and S-Series.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.5.0 Introduced on S55
Version 7.8.1.0 Introduced on S-Series