Command Line Reference Guide

848 | Quality of Service (QoS)
www.dell.com | support.dell.com
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 32-22. test cam-usage service-policy input policy-map linecard all Example
Command
port-set portpipe number Enter the keyword port-set followed by the line card’s port pipe
number.
Range: 0 or 1
linecard all (OPTIONAL) Enter the keywords linecard all to indicate all line
cards.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced on E-Series
Force10# test cam-usage service-policy input pmap_l2 linecard all
For a L2 Input Policy Map pmap_l2, the output must be as follows,
Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM | Status
| | | | per Port | (Allowed ports)
0 0 L2ACL 500 200 Allowed (2)
0 1 L2ACL 100 200 Exception
1 0 L2ACL 1000 200 Allowed (5)
1 1 L2ACL 0 200 Exception
…
…
…
13 1 L2ACL 400 200 Allowed (2)
Force10#
Note: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed and hence the output
contains only L2ACL CAM partition entries.
Table 32-7. test cam-usage Command Example Fields
Field Description
Linecard Indicates the line card slot number.
Portpipe Indicates the portpipe number.
CAM Partition The CAM space where the rules are added.
Available CAM Indicates the free CAM space, in the partition, for the classification rules.
Note: The CAM entries reserved for the default rules are not included in
the Available CAM column; free entries, from the default rules space, can
not be used as a policy map for the classification rules.