Command Line Reference Guide

834 | Quality of Service (QoS)
www.dell.com | support.dell.com
Usage
Information
rate-shape can be applied only as an aggregate policy. If it is applied as a class-based policy, then
rate-shape will not take effect.
Related
Commands
service-policy input
c e s
Apply an input policy map to the selected interface.
Syntax
service-policy input policy-map-name [layer2]
To remove the input policy map from the interface, use the no service-policy input
policy-map-name [layer2] command.
Parameters
Defaults
Layer 3
Command Modes
INTERFACE
Command
History
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the service-policy for those
interfaces. A policy map attached to an interface can be modified.
Related
Commands
rate shape Shape the traffic output of the selected interface.
qos-policy-output Create a QoS output policy.
policy-map-name
Enter the name for the policy map in character format (16 characters
maximum).
You can identify an existing policy map or name one that
does not yet
exist.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2
pre-Version 6.1.1.1 Introduced on E-Series
Note: The service-policy commands are not allowed on a port channel.
The service-policy input policy-map-name command and the service-class dynamic
dot1p
command are not allowed simultaneously on an interface. However, the service-policy
input
command (without the policy-map-name option) and the service-class dynamic
dot1p
command are allowed on an interface.
policy-map-input Create an input policy map.