Command Line Reference Guide

Quality of Service (QoS) | 831
queue ingress
e
Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the
Multicast bandwidth queue.
Syntax
queue ingress multicast {linecard slot number port-set number | all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard slot number port-set
number | all} [wred-profile name] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of queues. The
WRED Curve is applied to all eight ingress Multicast queues.
Related
Commands
linecard number
Enter the keyword linecard followed by the line card slot number.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300.
port-set number
Enter the keyword port-set followed by the line card’s port pipe.
Range: 0 or 1
all Enter the keyword all to apply to all line cards.
wred-profile name
(OPTIONAL) Enter the keyword wred-profile followed by your WRED
profile name in character format (16 character maximum). Or use one of the
pre-defined WRED profile names.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
Version 7.4.1.0 and 6.5.3.0 Introduced on E-Series
Note: The multicast-bandwidth option is not supported on queue ingress. If you attempt to
use the multicast-bandwidth option, the following reject error message is generated:
% Error:Bandwidth-percent is not allowed for ingress
multicast
show queue statistics ingress
Display the ingress queue statistics