Command Line Reference Guide

Control and Monitoring | 83
Command
History
Usage
Information
You cannot delete a terminal connection.
Related
Commands
linecard
c e
Pre-configure a line card in a currently empty slot of the system or a different line card type for the slot.
Syntax
linecard number card-type
To delete a card setting, use the no linecard number command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command only for empty slots or a slot where you have hot-swapped a different line card type.
Before inserting a card of a different type into the pre-configured slot, execute the no linecard
number command. The following screenshot shows the current supported C-Series line cards, along
with their “card types” (card-type IDs).
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
access-class Restrict incoming connections to a particular IP address in an IP access control list (ACL).
password Specify a password for users on terminal lines.
show linecard Display the line card(s) status.
number
Enter the number of the slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/E1200i, 0 to 6 on a E600/E6001, and 0 to 5 on a
E300.
card-type
Enter the line card ID (see the Supported Hardware section in the Release Notes).
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i
Version 7.5.1.0 Introduced on C-Series
E-Series original Command