Command Line Reference Guide

Quality of Service (QoS) | 825
match mac vlan
c e s
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
Defaults
None
Command Modes
CLASS-MAP
Command
History
Usage
Information
You must first enter the class-map command in order to access this command. You can match against
only one VLAN ID.
Related
Commands
policy-aggregate
c e s
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is
part of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use no policy-aggregate qos-policy-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (policy-map-input and policy-map-output)
This command is supported on C-Series, S-Series, and the S55 under policy-map-output only.
Command
History
Usage
Information
C-Series and S-Series
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate input/
output QoS policy can co-exist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-police)
will apply. Any marking configurations in aggregate input QoS policy will be ignored.
number
Enter the VLAN ID.
Range: 1–4094
Version 8.3.5.0 Introduced on S55
Version 8.2.0.1 Introduced
class-map Create/access a class map.
qos-policy-name
Enter the name of the policy map in character format (32 characters maximum)
Version 8.3.5.0 Introduced on S55
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series