Command Line Reference Guide

812 | Quality of Service (QoS)
www.dell.com | support.dell.com
Related
Commands
service-class bandwidth-percentage
c s
Specify a minimum bandwidth for queues
Syntax
service-class bandwidth-percentage queue0 number queue1 number queue2 number
queue3
number
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the command service-class
bandwidth-weight
from CONFIGURATION mode. The command is applied in the same way as the
bandwidth-weight command in an output QoS policy. The bandwidth-weight command in
QOS-POLICY-OUT mode supersedes the service-class bandwidth-weight command.
service-class dynamic dot1p
c e s
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or
on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes
INTERFACE mode entries.
Syntax
service-class dynamic dot1p
To return to the default setting, enter no service-class dynamic dot1p.
Defaults
All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled. Then the
default mapping is as follows:
Version 7.6.1.0 Introduced on S-Series and on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate-shape Shape traffic output as part of the designated policy.
number
Enter the bandwidth-weight, as a percentage. The value must be a power of 2.
Range 1-1024.
Version 8.3.5.0 Introduced on S55
Version 8.2.1.0 Introduced on C-Series and S-Series.
Table 32-1. Default dot1p to Queue Mapping
dot1p
E-Series
Queue ID
C-Series
Queue ID
S-Series
Queue ID
0211
1000
2100