Command Line Reference Guide

766 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
This address is used by first-hop routers to send Register packets on behalf of source multicast hosts.
The RP addresses are stored in the order in which they are entered. RP addresses learned via BSR take
priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take
precedence over the statically configured RPs.
ip pim rp-candidate
c e s
Configure a PIM router to send out a Candidate-RP-Advertisement message to the Bootstrap (BS)
router or define group prefixes that are defined with the RP address to PIM BSR.
Syntax
ip pim rp-candidate {interface [priority]
To return to the default value, enter no ip pim rp-candidate {interface [priority] command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address mask
Enter the keyword
group-address followed by a group-address mask, in
dotted decimal format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP.
The override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
Version 8.3.5.0 Introduced on S55
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
pre-Version 6.1.1.1 Introduced on E-Series
interface
Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For Port Channel interface types, enter the keyword
port-channel
followed by a number from 1 to 255.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: 192