Command Line Reference Guide

764 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Parameters
Defaults
None
Command Modes
INTERFACE
Command
History
Example
Figure 27-1. ip pim join-filter Command Example
Related
Commands
ip pim neighbor-filter
c e s
Configure this feature to prevent a router from participating in protocol independent Multicast (PIM).
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
Defaults
Defaults.
Command Modes
CONFIGURATION.
Command
History
Usage
Information
Do not enter this command before creating the access-list.
ext-access-list
Enter the name of an extended access list.
in
Enter this keyword to apply the access list to inbound traffic.
out
Enter this keyword to apply the access list to outbound traffic.
Version 8.3.5.0 Introduced on S55
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series
Version 7.7.1.0 Introduced on E-Series.
Force10(conf)# ip access-list extended iptv-channels
Force10(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Force10(config-ext-nacl)# permit ip any 232.1.1.0/24
Force10(config-ext-nacl)# permit ip 100.1.1.0/16 any
Force10(config-if-gi-1/1)# ip pim join-filter iptv-channels in
Force10(config-if-gi-1/1)# ip pim join-filter iptv-channels out
ip access-list
extended
Configure an access list based on IP addresses or protocols.
access-list
Enter the name of a standard access list. Maximum 16 characters.
Version 8.3.5.0 Introduced on S55
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on the E-Series