Command Line Reference Guide

762 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
ip pim dr-priority
c e s
Change the Designated Router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number
from 0 to 16383.
• For Port Channel interface types, enter the keyword
port-channel followed
by a number from 1 to 255.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length.
Range: zero (0) to 32
Default: 30
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: zero (0)
Version 8.3.5.0 Introduced on S55
Version 7.8.1.0 Introduced on S-Series
Version 6.1.1.0 Added support for VLAN interface
priority-value
Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1
Version 8.3.5.0 Introduced on S55
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series