Command Line Reference Guide

Control and Monitoring | 75
exec-timeout
ce s
Set a time interval the system will wait for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, enter no exec-timeout.
Parameters
Defaults
10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes
LINE
Command
History
Usage
Information
To remove the time interval, enter exec-timeout 0 0.
Example
Figure 4-4. FTOS time-out display
exit
ce s
Return to the lower command mode.
Syntax
exit
Command Modes
EXEC Privilege, CONFIGURATION, LINE, INTERFACE, TRACE-LIST, PROTOCOL GVRP,
SPANNING TREE, MULTIPLE SPANNING TREE, MAC ACCESS LIST, ACCESS-LIST,
AS-PATH ACL, COMMUNITY-LIST, PREFIX-LIST, ROUTER OSPF, ROUTER RIP, ROUTER
ISIS, ROUTER BGP
Command
History
minutes
Enter the number of minutes of inactivity on the system before disconnecting the current
session.
Range: 0 to 35791
Default: 10 minutes for console line; 30 minutes for VTY line.
seconds
(OPTIONAL) Enter the number of seconds
Range: 0 to 2147483
Default: 0 seconds
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
Force10 con0 is now available
Press RETURN to get started.
Force10>
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series