Command Line Reference Guide

732 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Command
History
Example
Figure 26-4. Command Example: show config
show ip ospf
c e s
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command output will not list
Area 0.
Example
Figure 26-5. Command Example: show ip ospf process-id
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Force10(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Force10(conf-router_ospf)#
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
vrf name
E-Series Only: Show only the OSPF information tied to the VRF process.
Version 8.3.5.0 Introduced on S55
Version 7.9.1.0 Introduced VRF
Version 7.9.1.0 Introduced VRF
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.8.1.0
Introduced
process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Force10>show ip ospf 1
Routing Process ospf 1 with ID 11.1.2.1
Supports only single TOS (TOS0) routes
It is an autonomous system boundaryrouter
SPF schedule delay 0 secs, Hold time between two SPFs 5 secs
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0.0.0.0)
Number of interface in this area is 2
SPF algorithm executed 4 times
Area ranges are
Force10>