Command Line Reference Guide

724 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
ip ospf transmit-delay
c e s
Set the estimated time elapsed to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
To return to the default value, enter no ip ospf transmit-delay.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
c e s
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
To disable the Syslog messages, enter no log-adjacency-changes.
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
maximum-paths
c e s
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, enter no maximum-paths.
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 8.3.5.0 Introduced on S55
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series