Command Line Reference Guide

72 | Control and Monitoring
www.dell.com | support.dell.com
enable
c e s
Enter the EXEC Privilege mode or any other privilege level configured. After entering this command,
you may need to enter a password.
Syntax
enable [level]
Parameters
Defaults
15
Command Modes
EXEC
Command
History
Usage
Information
Users entering the EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the enable password command to
configure a password for the enable command at a specific privilege level. If no privilege level is
specified, the default is privilege level 15.
Related
Commands
enable xfp-power-updates
c e s
Enable XFP power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
To disable XFP power updates, use the no enable xfp-power-updates command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
level
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
enable password Configure a password for the enable command and to access a privilege level.
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series