Command Line Reference Guide

Control and Monitoring | 71
Command Modes
EXEC Privilege
Command
History
do
c e s
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without
returning to the EXEC level.
Syntax
do command
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION
INTERFACE
Command
History
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Figure 4-3. Command Example: do
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
command
Enter an EXEC-level command.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
Force10(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
Force10(conf-if-te-5/0)#
Force10(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
Force10(conf-if-te-5/0)#
Force10(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Force10(conf-if-te-5/0)#