Command Line Reference Guide

Multiple Spanning Tree Protocol (MSTP) | 671
Related
Commands
protocol spanning-tree mstp
c e s
Enter the MULTIPLE SPANNING TREE mode to enable and configure the Multiple Spanning Tree
group.
Syntax
protocol spanning-tree mstp
To disable the Multiple Spanning Tree group, enter no protocol spanning-tree mstp command.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 23-2. protocol spanning-tree mstp Command Example
Usage
Information
MSTP is not enabled when you enter the MULTIPLE SPANNING TREE mode. To enable MSTP
globally on the switch, enter no disable while in MULTIPLE SPANNING TREE mode.
Refer to the FTOS Configuration Guide for more information on Multiple Spanning Tree Protocol.
Related
Commands
Defaults
Disable.
Command Modes
MULTIPLE SPANNING TREE
Usage
Information
Refer to the FTOS Configuration Guide for more information on Multiple Spanning Tree Protocol.
revision
c e s
The revision number for the Multiple Spanning Tree configuration
Syntax
revision range
To return to the default values, enter no revision.
msti Map the VLAN(s) to an MST instance
revision Assign revision number to the MST configuration.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Force10(conf)#protocol spanning-tree mstp
Force10(config-mstp)#no disable
disable Disable Multiple Spanning Tree.