Command Line Reference Guide

Control and Monitoring | 67
banner motd
c e s
Set a Message of the Day (MOTD) banner.
Syntax
banner motd c line c
To delete a Message of the Day banner, enter no banner motd.
Parameters
Defaults
No banner is configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable
command followed by the password. These banners are not displayed to users in EXEC (non-privilege)
mode.
Related
Commands
cam-audit linecard
e
Enable audit of the IPv4 forwarding table on all line cards.
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
To disable audit, use the no cam-audit linecard all ipv4-fib command
Parameters
Defaults
Disabled
c
Enter a delineator character to specify the limits of the text banner. In the above figures, the %
character is the delineator character.
line
Enter a text string for your message of the day banner message ending the message with your
delineator.
In the example figures above, the delineator is a percent character (%).
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
banner exec Sets a banner to be displayed when you enter the EXEC Privilege mode.
banner login Sets a banner to be displayed after successful login to the system.
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the IPv4
forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes of the
CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes