Command Line Reference Guide

644 | Layer 2
www.dell.com | support.dell.com
Related
Commands
tagged
c e s
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
tagged interface
To remove a tagged interface from a VLAN, use no tagged interface command.
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
When you use the no tagged command, the interface is automatically placed in the Default VLAN as
an untagged interface unless the interface is a member of another VLAN. If the interface belongs to
several VLANs, you must remove it from all VLANs to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one
VLAN at a time.
Related
Commands
track ip
c e s
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member
interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface command.
vlan-stack compatible Enable the Stackable VLAN feature on the selected VLAN.
interface vlan Configure a VLAN.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
untagged Specify which interfaces in a VLAN are untagged.