Command Line Reference Guide

64 | Control and Monitoring
www.dell.com | support.dell.com
audible cut-off
e
Turn off an audible alarm.
Syntax
audible cut-off
Defaults
Not configured.
Command Modes
EXEC Privilege
banner exec
c e s
Configure a message that is displayed when a user enters the EXEC mode.
Syntax
banner exec c line c
To delete a banner, enter no banner exec.
Parameters
Defaults
No banner is displayed.
ip ftp source-interface show util-threshold cpu
ip ftp username show util-threshold mem
ip telnet server enable ssh-peer-rpm
ip telnet source-interface ssh-peer-stack-unit
ip tftp source-interface telnet
line telnet-peer-stack-unit
linecard telnet-peer-stack-unit
module power-off terminal length
motd-banner terminal xml
ping traceroute
power-off undebug all
power-on show util-threshold cpu
reload util-threshold cpu (C- and E-Series)
reset util-threshold cpu (S-Series)
rpm <slot> location-led util-threshold mem (C- and E-Series)
send util-threshold mem (S-Series)
service timestamps upload trace-log
show alarms virtual-ip
show chassis write
c
Enter the keywords banner exec, and then enter a character delineator, represented here
by the letter
c, and press ENTER.
line
Enter a text string for your banner message ending the message with your delineator.
In the example below, the delineator is a percent character (%); the banner message is
“testing, testing”.