Command Line Reference Guide

614 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
lacp system-priority
c e s
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
To return to the default setting, use the no lacp system-priority priority-value command.
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
lacp ungroup member-independent
Enable BMP boot for the device connected to the LACP LAG.
Syntax lacp ungroup member-independent {port-channel port-channel-id}
Defaults
Not configured.
Command Modes
CONFIGURATION
Usage
Information
During boot-up in a stacking configuration, the system must be able to reach the
DHCP server with the image and configuration image. During bootup, only untagged
DHCP requests are sent to the DHCP server to receive an offer on static LAGs
between switches. The DHCP server must be configured to start in jumpstart mode. If
switches are connected using LACP port-channel like ToR, use the
port-channel
parameter on the TOR side of the configuration to allow member ports of a
completely un-grouped lacp port-channel to inherit vlan membership of that port
channel to ensure untagged packets reach the DHCP server located on the TOR. To
ungroup the port-channel configurations, use the
no lacp ungroup
member-independent
command.
Command
History
priority-value
Enter the port-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
Version 8.3.5.3 Introduced on S55
Version 8.3.3.8 Introduced on S60
Version 8.3.12.0 Added port-channel parameter.
Version 8.3.8.0 Introduced on S4810