Manualshelf

Command Line Reference Guide

ManualsBrandsDell ManualsserversDell Force10 S55T
601602603604605606607608609610
iSCSI Optimization | 601
Command
History
Usage
Information
• LLDP must be enabled before using this command.
• LLDP cannot be disabled if iSCSI is enabled.
iscsi priority-bits
Configure the priority bitmap to be advertised in iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults
4 (0x10 in the bitmap)
Command Modes
PROTOCOL LLDP (only on global, not on interface)
Command
History
iscsi profile-compellent
Configure the auto-detection of Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults
Compellent disk arrays are not detected.
Command Modes
INTERFACE
Command
History
.
Version 8.3.3.8 Introduced on the S60
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.5.3 Introduced on the S55
Version 8.3.3.8 Introduced on the S60
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module