Command Line Reference Guide

60 | File Management
www.dell.com | support.dell.com
Example
Command example: upgrade fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
upgrade fpga-image (S55)
Upgrade the FPGA version on the S55.
Syntax
upgrade fpga-image stack-unit
{0-11} booted
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
Example
Command example: upgrade fpga-image
Force10#conf
Force10(conf)# upgrade primary-fpga-flash rpm
Proceed to upgrade primary fpga flash for rpm 0 [confirm yes/no]: yes
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Force10#
reset
Reset a line card or RPM.
restore fpga-image
This command copies the backup FPGA image to the primary FPGA image.
stack-unit Enter the keyword stack-unit to upgrade the FPGA on the specified S55 chassis.
booted
Upgrade the FPGA image using the currently running FTOS image.
Version 8.3.5.0 Introduced on the S55
Force10#upgrade fpga-image stack-unit 0 booted
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
Unit0 S55 SYSTEM FPGA 15 16
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade fpga image for stack-unit 0 [yes/no]: yes
FPGA upgrade in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Unit 0 FPGA upgrade successful. Power cycle the stack-unit to complete the
upgrade.
Force10#