Command Line Reference Guide

IPv6 Basics | 599
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 18-5. Command Example: show ipv6 interface
show ipv6 route
c e s
Displays the IPv6 routes.
Syntax
show ipv6 route [ipv6-address prefix-length] [hostname] [all] [bgp as number] [connected]
[isis tag] [list prefix-list name] [ospf process-id] [rip] [static] [summary]
Parameter
loopback
(OPTIONAL) View information for IPv6 loopback interfaces.
port-channel
(OPTIONAL) View information for IPv6 port channels.
tengigabitethernet
(OPTIONAL) View information for an IPv6 tengigabitethernet interface.
vlan
(OPTIONAL) View information for IPv6 VLANs.
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced
Force10#show ipv6 interface gigabitethernet 1/1
GigabitEthernet 1/1 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe04:62c4
Global Unicast address(es):
2001::1, subnet is 2001::/64
2002::1, subnet is 2002::/120
2003::1, subnet is 2003::/120
2004::1, subnet is 2004::/32
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:1
ff02::1:ff04:62c4
MTU is 1500
ICMP redirects are not sent
DAD is enabled: number of DAD attempts: 1
ND reachable time is 30 seconds
ND advertised reachable time is 30 seconds
ND advertised retransmit interval is 30 seconds
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the
x:x:x:x::x format followed by the
prefix length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
hostname
(OPTIONAL) View information for this IPv6 routes with Host Name