Command Line Reference Guide

IPv6 Basics | 597
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
show ipv6 fib linecard
c e
View all Forwarding Information Base entries.
Syntax
show ipv6 fib linecard slot-number {summary | ipv6-address}
Parameters
Command Mode
EXEC
EXEC Privilege
Command
History
unit-number
Enter the stack unit’s ID number.
Unit ID range:
S55: 0-11
all other S-Series: 0-7
port-set
Enter the Port Set to
summary
(OPTIONAL) Enter the keyword
summary to display a table listing network
prefixes and the total number prefixes which can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM
ipv6-address
Enter the IPv6 address in the
x:x:x:x::x/n format to display networks that have
more specific prefixes.
Range: /0 to /128
Note: The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced
slot-number
Enter the number of the line card slot.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300
summary (OPTIONAL) Enter the keyword summary to view a summary of entries in IPv6 cam.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have more
specific prefixes.
Range: /0 to /128
Note: The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced