Command Line Reference Guide

594 | IPv6 Basics
www.dell.com | support.dell.com
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Example
Figure 18-2. Command Example: ipv6 route
Usage
Information
When the interface goes down, FTOS withdraws the route. The route is re-installed, by FTOS, when
the interface comes back up. When a recursive resolution is “broken,” FTOS withdraws the route. The
route is re-installed, by FTOS, when the recursive resolution is satisfied.
Related
Commands
ipv6 unicast-routing
c e
Enable IPv6 unicast routing.
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults
Enabled
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced
Force10(conf)#ipv6 route 44::0 /64 33::1 ?
<1-255> Distance metric for this route
permanent Permanent route
tag Set tag for this route
Force10(conf)#ipv6 route 55::0 /64 ?
X:X:X:X::X Forwarding router's address
gigabitethernet Gigabit Ethernet interface
loopback Loopback interface
null Null interface
port-channel Port channel interface
sonet Sonet interface
tenGigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
Force10(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 ?
<1-255> Distance metric for this route
X:X:X:X::X Forwarding router's address
permanent Permanent route
tag Set tag for this route
Force10(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 66::1 ?
<1-255> Distance metric for this route
permanent Permanent route
tag Set tag for this route
Force10#
show ipv6 route View the IPv6 configured routes.