Command Line Reference Guide

IPv6 Basics | 591

IPv6 Basics

Overview

IPv6 Basic Commands are supported on platforms c e and s as designated by the symbols

beneath the commands.

E-Series ExaScale supports IPv6 with FTOS 8.2.1.0 and later.

Commands

The IPv6 commands in the chapter are:

• clear ipv6 fib

• clear ipv6 route

• ipv6 address

• ipv6 unicast-routing

• show ipv6 cam linecard

• show ipv6 cam stack-unit

• show ipv6 fib linecard

• show ipv6 fib stack-unit

• show ipv6 interface

• show ipv6 route

• trust ipv6-diffserv

clear ipv6 fib

c e s

Clear (refresh) all FIB entries on a line card.

Syntax

clear ipv6 fib linecard slot

Parameters

Command Mode

EXEC Privilege

Note: The IPv6 basic commands are supported on all platforms. However, not all features

are supported on all platforms.

slot

Enter the slot number to clear the FIB for a line card.