Command Line Reference Guide

IPv6 Access Control Lists (IPv6 ACLs) | 589
Example
Figure 17-9. Command Example: route-map
Related
Commands
set ipv6 next-hop
c e
Configure a filter that specifies IPv6 address as the next hop.
Syntax
set ipv6 next-hop ipv6-address
To delete the setting, use the no set ipv6 next-hop ipv6-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Usage
Information
The set ipv6 next-hop command is the only way to set an IPv6 Next-Hop.
show config
c e
View the current route map configuration.
Syntax
show config
Command Modes
ROUTE-MAP
Command
History
Force10(conf)#route-map Rmap1
Force10(config-route-map)#match ?
…
ip IP specific information
ipv6 IPv6 specific information
…
show config View the current configuration.
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
Note: The
:: notation specifies successive hexadecimal fields of zeros
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Version 7.4.1.0 Introduced support on the E-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Version 7.4.1.0 Introduced support on the E-Series