Command Line Reference Guide

File Management | 57
Once the URL is specified, the same downloaded image can be used for upgrading an individual RPM,
line cards, SFM FPGA, and system-image for cache-boot without specifying the file-url again using the
command upgrade {bootflash-image | bootselector-image | system-image} {all | linecard
linecard-slot | rpm}. After 20 minutes, the cached memory is released and returned for general use, but
the URL is maintained and you do not have to specify it for subsequent upgrades.
Related
Commands
upgrade (S-Series management unit)
s
Upgrade the bootflash image or system image of the S-Series management unit.
Syntax
upgrade {boot | system} {ftp: | scp: | tftp: | flash: {A: |B:} | stack-unit | usbflash:} file-url
Parameters
Defaults
No configuration or default values
Command Modes
EXEC Privilege
Command
History
upgrade fpga-image (E-Series)
Upgrade the FPGA version in the specified E-Series SFM.
boot system (S55)
Display configured boot image information
boot
Enter this keyword to change the boot image.
system
Enter this keyword to change the system image.
ftp:
After entering this keyword you can either follow it with the location of the source file in
this form:
//userid:password@hostip/filepath, or press Enter to launch a prompt
sequence.
scp:
After entering this keyword you can either follow it with the location of the source file in
this form:
//userid:password@hostip/filepath, or press Enter to launch a prompt
sequence.
tftp:
After entering this keyword you can either follow it with the location of the source file in
this form:
//hostlocation/filepath, or press Enter to launch a prompt sequence.
flash:
After entering this keyword you can either follow it with the location of the source file in
this form:
flash//filepath,or press Enter to launch a prompt sequence.
S55 only
A: | B:
Enter the partition to upgrade from the flash.
S55 only
stack-unit:
After entering this keyword to synch the image to the stack-unit.
usbflash:
After entering this keyword you can either follow it with the location of the source file in
this form:
usbflash://filepath, or press Enter to launch a prompt sequence.
S55 only
Version 8.3.5.0 Introduced on the S55
Version 7.7.1.0 Added support for TFTP and SCP.
Version 7.6.1.0 Introduced on S-Series