Command Line Reference Guide

562 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
• ipv6 access-group
• ipv6 access-list
• permit
• permit icmp
• permit tcp
• permit udp
• remark
• resequence access-list
• resequence prefix-list ipv6
• seq
• show cam-acl
• show config
• show ipv6 accounting access-list
• show running-config acl
• test cam-usage
cam-acl
c s
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10}
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be
reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
default
Use the default CAM profile settings, and set the CAM as follows.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl) : 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl 1-10
ipv6acl
0-10 ipv4qos 1-10
l2qos 1-10
Allocate space to support IPv6 ACLs. You must enter all of the
profiles and a range.
Enter the CAM profile name followed by the amount to be allotted.
The total space allocated must equal 13.
The
ipv6acl range must be a factor of 2.
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series