Command Line Reference Guide

File Management | 55
Defaults
No configuration or default values
Command Modes
EXEC Privilege
Command
History
Usage
Information
A system message appears stating the Bootflash upgrade status. Reload the system to boot from the
upgraded boot images.
Once the URL is specified, the same downloaded image can be used for upgrading an individual RPM,
line cards, SFM FPGA, and system-image for cache-boot without specifying the file-url again using the
command upgrade {bootflash-image | bootselector-image | system-image} {all | linecard
linecard-slot | rpm}. After 20 minutes, the cached memory is released and returned for general use, but
the URL is maintained and you do not have to specify it for subsequent upgrades.
Related
Commands
upgrade (C-Series version)
c
Upgrade the bootflash or boot selector image on a processor.
Syntax
upgrade {bootflash-image | bootselector-image | system-image}
{all | linecard {number | all} | rpm} [booted | file-url | repair]
system-image Enter the keyword system-image to upgrade the cache boot image.
all Enter the keyword all to upgrade the bootflash/boot selector image on all
processors in the E-Series. This keyword does not upgrade the bootflash on
the standby RPM.
linecard linecard-slot
Enter the keyword linecard followed by the slot number to change the
bootflash image on a specific line card.
E-Series Range: 0 to 13 on the E1200; 0 to 6 for the E600; 0 to 5 on the
E300
rpm Enter the keyword rpm to upgrade the bootflash/boot selector image on all
processors on the RPM.
booted
Enter this keyword to upgrade using the image packed with the currently
running FTOS image.
file-url
Enter the following location keywords and information to upgrade using an
FTOS image other than the one currently running:
Enter the transfer method and file location:
flash://filename
ftp://userid
:password@hostip/filepath
slot0://filename
tftp://hostip
/filepath
Version 7.7.1.0
Removed
alt-bootflash-image, alt-bootselector-image, alt-system-image
options
, rp1, rp2, and cp options.
E-Series original Command
upgrade fpga-image (E-Series)
Upgrade the FPGA version in the specified E-Series SFM.
boot system (S55)
Display configured boot image information