Command Line Reference Guide

IPv4 Routing | 549
show ip management-route
c e
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 16-18. show ip management route Command Example
Table 16-13. show ip interface brief Column Headings
Field Description
Interface Displays type of interface and the associated slot and port number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method
Displays
Manual if the configuration is read from the saved configuration.
Status
States whether the interface is enabled (up) or disabled (administratively
down
).
Protocol
States whether IP is enabled (up) or disabled (down) on the interface.
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number
of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Version 8.3.5.0 Introduced on S55.
Version 8.3.3.1 Introduced on S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Force10#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
Force10#