Command Line Reference Guide
544 | IPv4 Routing
www.dell.com | support.dell.com
Example
Figure 16-13. show ip fib linecard Command Example
Related
Commands
show ip fib stack-unit
s
View all Forwarding Information Base (FIB) entries.
Syntax
show ip fib stack-unit id [ip-address [mask] [longer-prefixes] | summary]
Parameters
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Force10>show ip fib linecard 12
Destination Gateway First-Hop Mac-Addr Port VId Index E
C
-------------------- -------------------------- -------------- ---------------- ------- ------------
-
3.0.0.0/8 via 100.10.10.10, So 2/8 100.10.10.10 00:01:e8:00:03:ff So 2/8 0 60260
0
3.0.0.0/8 via 101.10.10.10, So 2/9
100.10.10.0/24 Direct, So 2/8 0.0.0.0 00:01:e8:00:03:ff So 2/8 0 11144
0
100.10.10.1/32 via 127.0.0.1 127.0.0.1 00:00:00:00:00:00 CP 0 3276
0
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10 00:01:e8:00:03:ff So 2/8 0 0
0
101.10.10.0/24 Direct, So 2/9 0.0.0.0 00:00:00:00:00:00 RP2 0 11145
0
101.10.10.1/32 via 127.0.0.1 127.0.0.1 00:00:00:00:00:00 CP 0 3277
0
101.10.10.10/32 via 101.10.10.10, So 2/9 101.10.10.10 00:01:e8:01:62:32 So 2/9 0 1
0
Force10>
Table 16-10. show ip fib linecard Command Example Fields
Field Description
Destination Lists the destination IP address.
Gateway
Displays either the word
direct and an interface for a directly
connected route or the remote IP address to be used to forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Index Displays the internal interface number.
EC Displays the number of ECMP paths.
clear ip fib stackunit Clear FIB entries on a specified line card.
id
Enter the S-Series stack unit ID.Unit ID range:
S55: 0-11
all other S-Series: 0-7
ip-address mask
(OPTIONAL) Enter the IP address of the network destination to view only
information on that destination.
Enter the IP address in dotted decimal format (A.B.C.D). You must enter the mask in
slash prefix format (/X).