Command Line Reference Guide

526 | IPv4 Routing
www.dell.com | support.dell.com
Related
Commands
ip host
c e s
Assign a name and IP address to be used by the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
ip max-frag-count
c e s
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, enter no ip max-frag-count.
Parameters
Defaults
No limit is set on number of fragments allowed.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip helper-address Specify the destination broadcast or host address for DHCP server requests.
show running-config Display the current configuration and changes from default values.
name
Enter a text string to associate with one IP address.
ip-address
Enter an IP address, in dotted decimal format, to be mapped to the name.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
count
Enter a number for the number of fragments allowed for re-assembly.
Range: 2 to 256
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series