Command Line Reference Guide

522 | IPv4 Routing
www.dell.com | support.dell.com
Usage
Information
You must be in the INTERFACE mode before you add an IP address to an interface. Assign an IP
address to an interface prior to entering the ROUTER OSPF mode.
ip directed-broadcast
c e s
Enables the interface to receive directed broadcast packets.
Syntax
ip directed-broadcast
To disable the interface from receiving directed broadcast packets, enter no ip directed-broadcast.
Defaults
Disabled (that is, the interface does not receive directed broadcast packets)
Command Modes
INTERFACE
Command
History
ip domain-list
c e s
Configure names to complete unqualified host names.
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Configure the ip domain-list command up to 6 times to configure a list of possible domain names.
If both the ip domain-name and ip domain-list commands are configured, the software will try to
resolve the name using the ip domain-name command. If the name is not resolved, the software goes
through the list of names configured with the ip domain-list command to find a match.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command.
• enable DNS with the ip domain-lookup command.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
name
Enter a domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series