Command Line Reference Guide

514 | IPv4 Routing
www.dell.com | support.dell.com
clear host
c e s
Remove one or all dynamically learnt host table entries.
Syntax
clear host name
Parameters
Command Modes
EXEC Privilege
Command
History
clear ip fib stackunit
c e s
Clear all Forwarding Information Base (fib) entries in the specified stack unit (use this command with
caution, see Usage Information below)
Syntax
clear ip fib stackunit ID
Parameters
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
Use this command to clear Layer 3 CAM inconsistencies.
Related
Commands
name
Enter the name of the host to delete.
Enter * to delete all host table entries.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
ID
Enter the stack unit ID.
S55 Range: 0-11
C-Series and S-Series Range: 0-7
E-Series Range: 0 to 13 on E12001200i, 0 to 6 on E600/E600i; 0 to 5 on E300
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.2 Introduced support on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.9.1.0 Introduced VRF on the E-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Caution: Executing this command will cause traffic disruption.
show ip fib linecard
Show FIB entries.