Command Line Reference Guide

484 | Interfaces
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 15-35. show interfaces gigabitethernet phy Command Example (Partial)
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series and S-Series
Version 6.5.4.0 Introduced on E-Series
Table 15-8. Lines in show interfaces gigabitethernet Command Example
Line Description
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected speed and
duplex.
Mode Status Displays auto negotiation fault information. When the interface completes
auto negotiation successfully, the autoNegComplete field and the linkstatus
field read “True.”
AutoNegotiation Advertise Displays the control words advertised by the local interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the types of
flow control supported by the local interface.
AutoNegotiation Remote
Partner’s Ability
Displays the control words advertised by the remote interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the types of
flow control supported by the remote interface
Force10#show int gigabitethernet 1/0 phy
Mode Control:
SpeedSelection: 10b
AutoNeg: ON
Loopback: False
PowerDown: False
Isolate: False
DuplexMode: Full
Mode Status:
AutoNegComplete: False
RemoteFault: False
LinkStatus: False
JabberDetect: False
AutoNegotation Advertise:
100MegFullDplx: True
100MegHalfDplx: True
10MegFullDplx: False
10MegHalfDplx: True
Asym Pause: False
Sym Pause: False
AutoNegotiation Remote Partner's Ability:
100MegFullDplx: False
100MegHalfDplx: False
10MegFullDplx: False
10MegHalfDplx: False
Asym Pause: False
Sym Pause: False
AutoNegotiation Expansion:
ParallelDetectionFault: False
...