Command Line Reference Guide

472 | Interfaces
www.dell.com | support.dell.com
Example
Figure 15-25. show config Command Example for the INTERFACE Mode
show config (from INTERFACE RANGE mode)
c e s
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
History
Example
Figure 15-26. show config (Bulk Configuration) Command Example
Force10(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
no shutdown
Force10(conf-if)#
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
Force10(conf)#interface range gigabitethernet 1/1 - 2
Force10(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
Force10(conf-if-range-gi-1/1-2)#