Command Line Reference Guide

462 | Interfaces
www.dell.com | support.dell.com
Example
Figure 15-17. interface vlan Command Example
Usage
Information
For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. See Chapter 7, Access Control Lists (ACL).
Related
Commands
ipg (10 Gigabit Ethernet interfaces)
e
Set the Inter-packet Gap for traffic on 10 Gigabit Ethernet interface.
Syntax
ipg {ieee-802.3ae | shrink}
To return to the default of averaging the IPG, enter no ipg {shrink | ieee-802.3ae}
Parameters
Defaults
averaging the IPG
Command Modes
INTERFACE
Command
History
Usage
Information
For 10 Gigabit Ethernet interfaces only.
IPG equals 96 bits times from end of the previous packet to start of the pre-amble of the next packet.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
Force10(conf)#int vlan 3
Force10(conf-if-vl-3)#
interface Configure a physical interface.
interface loopback Configure a loopback interface.
interface null Configure a null interface.
interface port-channel Configure a port channel group.
show vlan Display the current VLAN configuration on the switch.
shutdown Disable/Enable the VLAN.
tagged Add a Layer 2 interface to a VLAN as a tagged interface.
untagged Add a Layer 2 interface to a VLAN as an untagged interface.
ieee-802.3ae Enter the keyword ieee-802.3ae to set the IPG to 12 (12-15) bytes (packet size
dependent)
shrink Enter the keyword shrink to set the IPG to 8 (8-11) bytes (packet size dependent).
pre-Version 6.1.1.0
Introduced for E-Series