Command Line Reference Guide

Interfaces | 461
interface range macro name
c e s
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
Defaults
This command has no default behavior or value
Command Modes
CONFIGURATION
Command
History
Usage
Information
Figure 15-16 runs the macro named test that was defined in Figure 15-15.
Example
Figure 15-16. interface-range macro Command Example
Related
Commands
interface vlan
c e s
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command
History
name
Enter the name of an existing macro.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced
Force10(config)#interface range macro test
Force10(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Force10
interface range Configure a range of command (bulk configuration)
interface range macro (define) Define a macro for an interface range (bulk configuration)
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale