Command Line Reference Guide

456 | Interfaces
www.dell.com | support.dell.com
interface ManagementEthernet
c e
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface ManagementEthernet slot/port
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 15-7. interface ManagementEthernet Command Example
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address command to assign an
IP address to the Management port.
Related
Commands
interface null
c e s
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
Defaults
Not configured; number = 0
Command Modes
CONFIGURATION
Command
History
slot/port
Enter the keyword ManagementEthernet followed by slot number (0-1) and port
number zero (0).
Version 8.3.5.0 Introduced on S55
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced for C-Series
Version 6.4.1.0 Introduced for E-Series
Force10(conf)#interface managementethernet 0/0
Force10(conf-if-ma-0/0)#
management route Configure a static route that points to the Management interface or a
forwarding router.
duplex (Management) Clear FIB entries on a specified line card.
speed (Management interface) Clear FIB entries on a specified line card.
number
Enter zero (0) as the Null interface number.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series