Command Line Reference Guide

444 | Interfaces
www.dell.com | support.dell.com
• keepalive
• lfs enable
• link debounce-timer
• monitor
• mtu
• negotiation auto
• portmode hybrid
• rate-interval
• show config
• show config (from INTERFACE RANGE mode)
• show interfaces
• show interfaces configured
• show interfaces dampening
• show interfaces description
• show interfaces linecard
• show interfaces phy
• show interfaces stack-unit
• show interfaces status
• show interfaces switchport
• show interfaces transceiver
• show range
• shutdown
• speed (for 10/100/1000 interfaces)
• speed (Management interface)
• switchport
• wanport
auto-mdix
Enable Auto-MDIX on copper ports.
Syntax
[no] auto-mdix
Defaults
Enabled
Command Modes
INTERFACE
Command
History
Usage
Information
With Auto-MDIX enabled, you can connect two network devices irrespective of the cable type
(straight-through or crossover) and the MDI mode of the peer device. When Auto-MDIX is disabled at
both ends, the copper ports behave as MDI. In this case, you need a crossover cable to connect the port
to another MDI port, or a straight-through cable to connect the port to a MDIX port. The link will not
come up when wrong cables are used.
Version 8.3.5.3 Introduced on the S55.
Version 8.3.3.3 Introduced on the S60.