Command Line Reference Guide

442 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Command
History
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This is useful when
there is no multicast router present in the VLAN because the multicast traffic does not need to be
routed. An IP address must be assigned to the VLAN interface for the switch to act as a querier for this
VLAN.
show ip igmp snooping mrouter
c e s
Display multicast router interfaces.
Syntax
show ip igmp snooping mrouter [vlan number]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 14-3. show ip igmp snooping mrouter Command Example
Related
Commands
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
vlan number
Enter the keyword vlan followed by the vlan number.
Range: 1-4094
Version 8.3.5.0 Introduced on the S55
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
Force10#show ip igmp snooping mrouter
Interface Router Ports
Vlan 2 Gi 13/3, Po 1
Force10#
show ip igmp groups Use this IGMP command to view groups