Command Line Reference Guide

GARP VLAN Registration (GVRP) | 421
Leave All Timer—The Leave All Timer starts when a GARP application entity starts. When this timer
expires, the entity sends a leave-all message so that other entities can re-register their attribute
information. Then, the leave-all time begins again.
Related
Commands
gvrp enable
c e s
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults
Disabled
Command Modes
CONFIGURATION-INTERFACE
Command
History
Related
Commands
gvrp registration
c e s
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
Defaults
Default registration is normal
Command Modes
CONFIGURATION-INTERFACE
Command
History
show garp timers Display the current GARP times
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series
disable Globally disable GVRP.
fixed
Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set.
This is the default
forbidden Enter the keyword forbidden followed by the VLAN range in a comma
separated VLAN ID set.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series