Command Line Reference Guide

420 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Command
History
Related
Commands
garp timers
c e s
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all} command.
Parameters
Defaults
Default as above
Command Modes
CONFIGURATION-GVRP
Command
History
Usage
Information
Join Timer—Join messages announce the willingness to register some attributes with other
participants. Each GARP application entity sends a Join message twice, for reliability, and uses a join
timer to set the sending interval.
Leave Timer—Leave announces the willingness to de-register with other participants. Together with
the Join, Leave messages help GARP participants complete attribute reregistration and de-registration.
Leave Timer starts upon receipt of a leave message sent for de-registering some attribute information.
If a join message is not received before the leave time expires, the GARP application entity removes
the attribute information as requested.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series
gvrp enable Enable GVRP on physical interfaces and LAGs.
protocol gvrp Access GVRP protocol
join
Enter the keyword join followed by the number of milliseconds to configure the join
time.
Range: 100-2147483647 milliseconds
Default: 200 milliseconds
Note: Designate the milliseconds in multiples of 100
leave Enter the keyword leave followed by the number of milliseconds to configure the leave
time.
Range: 100-2147483647 milliseconds
Default: 600 milliseconds
Note: Designate the milliseconds in multiples of 100
leave-all Enter the keyword leave-all followed by the number of milliseconds to configure the
leave-all time.
Range: 100-2147483647 milliseconds
Default: 1000 milliseconds
Note: Designate the milliseconds in multiples of 100
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series