Command Line Reference Guide

GARP VLAN Registration (GVRP) | 419
Command Modes
EXEC
Command
History
Related
Commands
debug gvrp
c e s
Enable debugging on GVRP.
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the
no debug gvrp {config | events | pdu} command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
c e s
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series
show gvrp statistics Display the GVRP statistics
config Enter the keyword config to enable debugging on the GVRP configuration.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port
or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by the Port
Channel number:
C-Series and S-Series Range: 1-128
E-Series Range: 1-255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version 8.3.5.0 Introduced on the S55.
Version 7.6.1.0 Introduced on C, E, and S-Series