Command Line Reference Guide

Dell Force10 Resilient Ring Protocol (FRRP) | 415
Example 1
Figure 12-2. show frrp summary Command Example
Example 2
Figure 12-3. show frrp ring-id Command Example
Example 3
Figure 12-4. show frrp ring-id summary Command Example
Related
Commands
timer
c e s
Set the hello or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-interval
milliseconds} command.
Force10#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
Force10#
Force10#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary: GigabitEthernet 0/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Force10#
Force10#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Force10#
protocol frrp Enter the Resilient Ring Protocol and designate a ring identification